# 50m² Resin Driveway Cost (UK 2026): £2,000 – £6,000

> What a 50m² resin driveway costs in the UK — £2,000 to £6,000 on published cost-guide rates, with the figures each guide gives for this size.

Source: https://resindrivewayprices.co.uk/50m2-resin-driveway-cost/

Plain-text mirror of the HTML page at the canonical URL above. Published for AI crawlers and agents; the HTML version is the indexable one.

---

A 50m² resin driveway (two cars side by side) costs £2,000 to £6,000 on published UK cost-guide rates.

Typical shape: about 6m wide by 8.5m deep — the standard two-car detached frontage.

## Why this size, specifically

The most consequential disagreement on this site. For the same 50m² drive, HomeHow says £2,150 to £2,500 and Checkatrade says £6,000 — nearly three times as much. Checkatrade calls £6,000 the average cost of a medium resin bound driveway in 2026; HomeHow's guide is a year older. If you only read one of them you would think the other was being quoted by a cowboy.

## What the guides publish for this size
- **HomeHow** — £2,150 – £2,500 (stated total for a 50m² two-car drive)
- **Checkatrade** — £6,000 (stated total for a 50m² medium drive, described as the UK average)

## Ask what the quote includes before comparing it

Most of the gap between those two figures is scope. Checkatrade prices a full job including groundwork; HomeHow is closer to a supply-and-lay rate over an existing base. Two quotes for a 50m² drive that differ by £3,000 are usually not pricing the same work.

## 50m² is where bulk buying starts to help

Checkatrade notes material cost per m² falls as the driveway gets bigger, because of bulk buying. At 50m² you are ordering enough aggregate and resin for that to register — it is one reason the per-m² rate drops from the small band.

## Budget for the base honestly

On the published rates, excavating and re-basing 50m² is £1,250 to £2,500 before a drop of resin is laid. That single decision moves a 50m² drive from the bottom of the range to the middle of it.

## Groundwork and extras

These are the lines that decide whether a resin drive costs £2,000 or £6,000. Only MyBuilder itemises them; the other guides fold them into the per-m² rate or leave them out entirely.

| Item | Published cost | Source | What drives it |

| --- | --- | --- | --- |

| Excavate and remove the existing surface | £10 – £20 per m² | MyBuilder | Varies with site conditions and how easily a machine and a grab lorry can reach the drive. |

| New Type 1 MOT sub-base | £15 – £30 per m² | MyBuilder | Needed whenever the existing base is broken up, or there was never one. Resin laid on a bad base fails at the edges first. |

| Removing an existing resin driveway | £800 – £1,800 whole job | MyJobQuote | Quoted as a whole-job figure rather than per m². |

| Edging or borders | £15 – £40 per linear metre | MyBuilder | Resin bound has to be laid up to a firm edge. With walls or an existing kerb you may need none of this; an open drive needs it all the way round. |

| Drainage improvement | £300 – £1,000 whole job | MyBuilder | Only needed where the ground does not take water away on its own. |

| Soakaway installation | £660 – £1,200 whole job | MyJobQuote | MyJobQuote puts a typical soakaway at around £850, smaller systems from £660 and larger ones at £1,000–£1,200. HomeHow gives £700–£1,000 for the same job. Most likely on clay ground, or when laying over a non-permeable base. |

| Dropped kerb | £370 – £2,000 whole job | HomeHow | The widest disagreement of any figure on this site. HomeHow says the work starts from £300 plus a £70–£100 council application; MyJobQuote puts the average at around £2,000. It is council-dependent, and it is a separate job from the driveway. |